Installation Guide

Step 1

Step 1

First trim the sheets so they interlock using a sharp stanley knife so all the panels are molded the same. Keep them the same way up or the interlock will not work.
Step 2

Step 2

You will need to create a straight edge for your starting panel. Use a ruler as a marker and draw a straight line down one side of the panel.
Step 3

Step 3

Using a stanley knife or a fine tooth saw cut along your marked line to give you a straight edge.
Step 4

Step 4

Place your cut panel onto the wall at one end and mount using a strong form of adhesive, screws or staples. (Note: staples can only be used when applying faux brick to a stud or plastered wall).
Step 5

Step 5

You can now slot your second panel into the panel attached to the wall and repeat this process systematically until the wall is covered.
Step 6

Step 6

Once the surface is covered with the panels fill in the joints using an acrylic white mastic or plaster.
Step 7

Step 7

Then brush the joints using a wet thin paintbrush.
Step 8

Step 8

Allow the mastic/plaster to dry before moving onto Step 9.
Step 9

Step 9

For colored brick only

Once the joints are completely dry, brush over the base/mortar color provided using a thin brush. Once this paint has dried use a wet brush to apply the age/touch up colour provided to the joints. Please note; this is a thin coat and really only a wash of color.

Whilst wet dab with a rag or a sponge until the joints are blended in with the surrounding panels.

If you have any questions please call our technical team to discuss on +1 (727) 475 5725 or alternatively drop us an email and we'll come back to you shortly This email address is being protected from spambots. You need JavaScript enabled to view it.

USA Office Contact Details

Address: Faux Brickwork, 4500, 140th Avenue North Suite 101 Clearwater FL 33762 Florida, United States
Tel: +1 (727) 475 5725
Email: enquiries@fauxbrickwork.com

More USA Office Details & Map